And next comes a very pleasant surprise. The boards simply dropped into place! I no longer have to tilt the boards in at an angle. it’s simply dropped down and done.
V1 is slightly more complex as one has to tilt the boards, while making sure the GPIO pins line up. V2 assembly is a lot less fiddly.
Looking at the rear everything still looks somewhat aligned. Thumbs up on making assembly easier. This is my third case, so maybe some experience helps. But it only took me 2 minutes to assemble my third Argon One 40 case.
The timing could be every quicker if the two long screws wasn’t stuck together (Top left). This is about the only flaw I have with my V2 so far.