Editing Your Curves - MultEQ Filter Frequency Range
By default the Audyssey filter is applied all the way to 20 kHz. You can adjust where the filter stops here. Click the area marked by the yellow arrow to switch to another speaker set. Here’s the default target curve for the Front speakers.
And this is the target curve for the sub-woofer.
Adjust the vertical dashed line to where you want the filtering to stop. The cut off frequency is shown in the blue box next to the line. This is an example where the cut off is at around 5 kHz. This means I am EQ my mains up to the 5 kHz band, the rest will be passed unprocessed.
Click the ‘Done’ button after you are finished.
Comment from: Andy Visitor
The hints how to copy and rename curves helped me a lot. Unfortunately the app is often not self-explanatory. Many thanks for your work.
Comment from: Niravana Visitor
A big THANK YOU for your article! This is what the user manual should have been! I followed it all the way through and successfully made the measurements, edit the curves, and uploaded to the receiver (Marantz AVR7012) , all in the First Try! However, the second try did not go so well. The app kept losing the receiver and I had to start over several times…… That’s probably is one of the reasons for low ratings. I finally noted your suggestion and use the IP address to "help" the app find the receiver. All my equipments are on a wired network, and the tablet was less than 5 feet away from the router. Never had any connection problem on wi-fi .
Yes, the app is great , if it’s consistent. My cons are:
- Occasional loss of contact with receiver… "may" be handled by giving it the IP address to search on retry.
- Slow. It took me about an hour to upload the data to the receiver (AVR 7013 and Galaxy TAB-A). Many times I thought it was hung, but just waited it out.
Many thanks again for a very helpful article.