Editing Your Curves - Audyssey Settings
You have already setup some basic Audyssey DSP modes during calibration. If you made a mistake then you can always return here to adjust them.
And that’s all the options explained. Next I’d show you how to backup your measurements and also how to upload the curves to your receiver. If you are new to this, make sure you have created a backup of your measurements before you attempt your first edit.
You need to re-do your calibration all over again if the file gets corrupted and you have no backups to restore from.
A Word From Our Sponsors
Comment from: Andy Visitor
The hints how to copy and rename curves helped me a lot. Unfortunately the app is often not self-explanatory. Many thanks for your work.
Comment from: Niravana Visitor
A big THANK YOU for your article! This is what the user manual should have been! I followed it all the way through and successfully made the measurements, edit the curves, and uploaded to the receiver (Marantz AVR7012) , all in the First Try! However, the second try did not go so well. The app kept losing the receiver and I had to start over several times…… That’s probably is one of the reasons for low ratings. I finally noted your suggestion and use the IP address to "help" the app find the receiver. All my equipments are on a wired network, and the tablet was less than 5 feet away from the router. Never had any connection problem on wi-fi .
Yes, the app is great , if it’s consistent. My cons are:
- Occasional loss of contact with receiver… "may" be handled by giving it the IP address to search on retry.
- Slow. It took me about an hour to upload the data to the receiver (AVR 7013 and Galaxy TAB-A). Many times I thought it was hung, but just waited it out.
Many thanks again for a very helpful article.