Uploading Your Curves - To The Receiver
You’d need to upload your measurements to the receiver in order for the DSP to apply. Doing this is similar to backing up your settings. Click the ‘Upload’ button:
And select ‘Send To AV Receiver’.
Select the curves to send.
Select the receiver to upload to.
Click ‘Accept’ to upload. And wait for the process to finish. This should take only 10 seconds or so.
Once completed you’d be back to the ‘Select An AV Receiver’ screen. Click the ‘Done’ button to return.
And that’s it. You have uploaded your first Audyssey configuration via the MultEQ editor app. Now repeat the process of adjusting the target curves, uploading, auditioning until you are happy with how it sounds.
Comment from: Andy Visitor
The hints how to copy and rename curves helped me a lot. Unfortunately the app is often not self-explanatory. Many thanks for your work.
Comment from: Niravana Visitor
A big THANK YOU for your article! This is what the user manual should have been! I followed it all the way through and successfully made the measurements, edit the curves, and uploaded to the receiver (Marantz AVR7012) , all in the First Try! However, the second try did not go so well. The app kept losing the receiver and I had to start over several times…… That’s probably is one of the reasons for low ratings. I finally noted your suggestion and use the IP address to "help" the app find the receiver. All my equipments are on a wired network, and the tablet was less than 5 feet away from the router. Never had any connection problem on wi-fi .
Yes, the app is great , if it’s consistent. My cons are:
- Occasional loss of contact with receiver… "may" be handled by giving it the IP address to search on retry.
- Slow. It took me about an hour to upload the data to the receiver (AVR 7013 and Galaxy TAB-A). Many times I thought it was hung, but just waited it out.
Many thanks again for a very helpful article.