Receivers Supported By The Audyssey MultEQ Editor
The MutliEQ app only works on the following receivers for now:
|Denon||AVR-X6300H, AVR-X4300H, AVR-X3300W, AVR-X2300W, AVR-X1300W, AVR-S920W, AVR-S720W, AVR-S930H, AVR-S730H, AVR-X1400H, AVR-X2400H, AVR-X3400H, AVR-X4400H, AVR-X6400H, AVR-X8500H, AVR-S740H, AVR-S940H, AVR-X1500H, AVR-X2500H|
|Marantz||AV7703, SR7011, SR6011, SR5011, NR1607, NR1608, SR5012, SR6012, SR7012, SR8012, AV7704, AV8805, NR1609|
I am running the MultEQ editor with my XiaoMi MiMix 2. This device has plenty of CPU grunt, free space and RAM and I am happy to say this app works beautifully. No problems at all when it comes to finding my 8805, analysing or uploading the profiles.
This app is where you will be doing all your Audyssey calibrations from henceforth. If you are taking 8 measures from the same position, you can do it all now via this app. Gone are the days where you will have to stay in room to press that ‘OK’ button to move to the next phrase.
While this app works for me, note that it is not a guarantee you will not experience problems or difficulties. To give you a better chance of success:
- Update your receiver to the latest firmware before purchasing this app.
- Make sure you have enough free space on your android device
- Ensure you have good WIFI reception
- Reboot the phone before starting MultEQ Editor
Should there be a problem, you can uninstall the app within 15 (or 30 minutes?) to get a full refund.
As always comment below when you have difficulties and I will try and help where I can.
Comment from: Andy Visitor
The hints how to copy and rename curves helped me a lot. Unfortunately the app is often not self-explanatory. Many thanks for your work.
Comment from: Niravana Visitor
A big THANK YOU for your article! This is what the user manual should have been! I followed it all the way through and successfully made the measurements, edit the curves, and uploaded to the receiver (Marantz AVR7012) , all in the First Try! However, the second try did not go so well. The app kept losing the receiver and I had to start over several times…… That’s probably is one of the reasons for low ratings. I finally noted your suggestion and use the IP address to "help" the app find the receiver. All my equipments are on a wired network, and the tablet was less than 5 feet away from the router. Never had any connection problem on wi-fi . Yes, the app is great , if it’s consistent. My cons are:
- Occasional loss of contact with receiver… "may" be handled by giving it the IP address to search on retry.
- Slow. It took me about an hour to upload the data to the receiver (AVR 7013 and Galaxy TAB-A). Many times I thought it was hung, but just waited it out.
Many thanks again for a very helpful article.