Editing Your Curves - Room Correction Results
Room Correction Results shows the raw measure response and the simulated response after Audyssey filters are applied. Here are the results of my front stage (Left, Right, Center and subwoofer).
These charts are irritating on two counts:
- Both axis unmarked. One can only assume every Y axis markers is 5 dB, while the major X markers are 100 Hz, 1 kHz and 10 kHz respectively.
- No idea what smoothing filters are been applied.
I’m sure the information is available somewhere, these should be included right inside the App!
You can scroll left and right to look at all your speakers. Hit the ‘Done’ or Android ‘back’ button to get back to the options menu.
A Word From Our Sponsors
Comment from: Andy Visitor
The hints how to copy and rename curves helped me a lot. Unfortunately the app is often not self-explanatory. Many thanks for your work.
Comment from: Niravana Visitor
A big THANK YOU for your article! This is what the user manual should have been! I followed it all the way through and successfully made the measurements, edit the curves, and uploaded to the receiver (Marantz AVR7012) , all in the First Try! However, the second try did not go so well. The app kept losing the receiver and I had to start over several times…… That’s probably is one of the reasons for low ratings. I finally noted your suggestion and use the IP address to "help" the app find the receiver. All my equipments are on a wired network, and the tablet was less than 5 feet away from the router. Never had any connection problem on wi-fi .
Yes, the app is great , if it’s consistent. My cons are:
- Occasional loss of contact with receiver… "may" be handled by giving it the IP address to search on retry.
- Slow. It took me about an hour to upload the data to the receiver (AVR 7013 and Galaxy TAB-A). Many times I thought it was hung, but just waited it out.
Many thanks again for a very helpful article.